Rear

REAR AXLE HUB

ON-VEHICLE INSPECTION
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
3. REMOVE REAR DISC
4. INSPECT REAR AXLE HUB BEARING FOR LOOSENESS





a) Using a dial indicator, check for looseness near the center of the axle hub.
Maximum: 0.05 mm (0.0020 inch)

NOTICE: Ensure that the dial indicator is set perpendicular to the measurement surface. If looseness exceeds the maximum, replace the axle hub assembly.

5. INSPECT REAR AXLE HUB FOR RUNOUT





a) Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
Maximum: 0.05 mm (0.0020 inch)

NOTICE: Ensure that the dial indicator is set perpendicular to the measurement surface. If runout exceeds the maximum, replace the axle hub assembly.

6. INSTALL REAR DISC
7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
8. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 inch lbs.)