Canister Purge Control Valve: Service and Repair
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE V-BANK COVER
a. Remove the 2 nuts and cover.
3. REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for EVAP)
a. Disconnect the connector and 2 hoses.
b. Remove the bolt and VSV.
INSTALLATION
1. INSTALL VACUUM SWITCHING VALVE ASSEMBLY (for EVAP)
a. Install the EVAP VSV with the bolt.
Torque: 18 N.m (184 kgf.cm, 13 ft.lbf)
b. Connect the 2 hoses and connector.
2. INSTALL V-BANK COVER
a. Install the cover with the 2 nuts.
Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf)
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.