Initialization

INITIALIZATION

NOTE: When disconnecting the cable from negative (-) battery terminal, initialize the following system(s) after the terminal is reconnected.

The initialization procedures are given in the table.
- Power Window Control System
- Intuitive Parking Assist System
- Variable Gear Ratio Steering System

1. RESET (INITIALIZE) POWER WINDOW REGULATOR MOTOR

NOTE: The power window regulator motor (initializing the pulse sensor) must be reset if: 1) the battery cable has been disconnected; 2) the power window regulator master switch, wire harness, power window regulator switch, window regulator, or power window regulator motor are replaced or removed / installed; or 3) the DC/DC or MPX-B fuses are replaced. If resetting is not performed, the master switch will not be able to operate the AUTO operation function, jam protection function and remote UP / DOWN function.

a. Turn the engine switch on (IG).
b. Open the power window halfway by pressing the power window switch.
c. Fully pull up the switch until the power window is fully closed and continue to hold the switch for at least 1 second.
d. Check that the AUTO UP / DOWN function operates normally.

HINT: If the AUTO UP / DOWN function operates normally, reset operations are completed. If abnormal, perform the 2 steps below.

e. Disconnect the cable from the negative (-) battery terminal for 10 seconds or more.
f. Reconnect the cable.
g. Repeat the first 4 steps of resetting the power window regulator motor.

HINT: If the remote UP / DOWN function does not operate after the conditions 1), 2), or 3) is satisfied, the power window regulator master switch may have a malfunction.