Transmission Speed Sensor: Service and Repair
SPEED SENSORCOMPONENTS:
REMOVAL
1. REMOVE NO. 2 ENGINE UNDER COVER
2. REMOVE SPEED SENSOR (NT)
(a) Disconnect the sensor connector.
(b) Remove the bolt and speed sensor.
(c) Remove the O-ring from the speed sensor.
3. REMOVE SPEED SENSOR (SP2)
(a) Disconnect the speed sensor connector.
(b) Remove the bolt and speed sensor.
(c) Remove the O-ring from the speed sensor.
INSPECTION
1. INSPECT SPEED SENSOR (NT)
(a) Measure the resistance according to the value(s) in the table.
Standard resistance:
If the resistance value is not as specified, replace the speed sensor.
2. INSPECT SPEED SENSOR (SP2)
(a) Measure the resistance according to the value(s) in the table.
Standard resistance:
If the resistance value is not as specified, replace the speed sensor.
INSTALLATION
1. INSTALL SPEED SENSOR (SP2)
(a) Coat a new O-ring with ATF and install it to the speed sensor.
(b) Install the speed sensor with the bolt.
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
(c) Connect the sensor connector.
2. INSTALL SPEED SENSOR (NT)
(a) Coat a new O-ring with ATF and install it to the speed sensor.
(b) Install the speed sensor with the bolt.
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
(c) Connect the sensor connector.
3. INSTALL NO. 2 ENGINE UNDER COVER