Ignition Coil: Service and Repair

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE COOL AIR INTAKE DUCT SEAL
3. REMOVE ENGINE ROOM SIDE COVER LH
4. REMOVE ENGINE ROOM SIDE COVER RH
5. REMOVE V-BANK COVER
6. DISCONNECT NO. 2 VENTILATION HOSE
7. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
8. REMOVE IGNITION COIL ASSEMBLY




a. Detach the 3 wire harness clamps and disconnect the noise filter connector.
b. Disconnect the 6 ignition coil connectors.




c. Remove the 6 bolts and the 6 ignition coils.

INSTALLATION

1. INSTALL IGNITION COIL ASSEMBLY




a. Install the 6 ignition coils with the 6 bolts.

Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)

b. Connect the 6 ignition coil connectors.




c. Attach the 3 wire harness clamps and connect the noise filter connector.

2. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
3. INSTALL NO. 2 VENTILATION HOSE
4. INSTALL V-BANK COVER
5. INSTALL ENGINE ROOM SIDE COVER LH
6. INSTALL ENGINE ROOM SIDE COVER RH
7. INSTALL COOL AIR INTAKE DUCT SEAL
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.