Fuel Pressure Pulsation Damper: Service and Repair

REMOVAL

1. PRECAUTION
2. DISCHARGE FUEL SYSTEM PRESSURE
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

4. REMOVE COOL AIR INTAKE DUCT SEAL
5. REMOVE ENGINE ROOM SIDE COVER LH
6. REMOVE ENGINE ROOM SIDE COVER RH
7. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH
8. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH
9. REMOVE FRONT FENDER TO COWL SIDE SEAL LH
10. REMOVE FRONT FENDER TO COWL SIDE SEAL RH
11. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
12. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
13. REMOVE COWL TOP VENTILATOR LOUVER SUBASSEMBLY
14. REMOVE V-BANK COVER SUB-ASSEMBLY
15. DISCONNECT NO. 2 VENTILATION HOSE
16. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
17. REMOVE FUEL PRESSURE PULSATION DAMPER




a. Using SST, remove the fuel pressure pulsation damper and 2 gaskets, and disconnect the fuel tube from the fuel pump.

SST 09612-24014 (09617-24011)

INSTALLATION

1. INSTALL FUEL PRESSURE PULSATION DAMPER




a. Temporarily install 2 new gaskets, the fuel tube and the fuel pressure pulsation damper to the fuel pump.
b. Using SST, tighten the fuel pressure pulsation damper.

SST 09612-24014 (09617-24011)

Torque:
without SST 40 N.m (408 kgf.cm, 30 ft.lbf)
with SST 35 N.m (357 kgf.cm, 26 ft.lbf)

HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
- Make sure SST and wrench are connected in a straight line.

2. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
3. CONNECT NO. 2 VENTILATION HOSE
4. INSTALL COWL TOP VENTILATOR LOUVER SUBASSEMBLY
5. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH
6. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH
7. INSTALL FRONT FENDER TO COWL SIDE SEAL LH
8. INSTALL FRONT FENDER TO COWL SIDE SEAL RH
9. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH
10. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH
11. INSTALL V-BANK COVER SUB-ASSEMBLY
12. INSTALL ENGINE ROOM SIDE COVER RH
13. INSTALL ENGINE ROOM SIDE COVER LH
14. INSTALL COOL AIR INTAKE DUCT SEAL
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
16. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.