Power Mirror Switch: Service and Repair

OUTER MIRROR SWITCH

Outer Mirror Switch:

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH
3. REMOVE CONSOLE UPPER PANEL ASSEMBLY
4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH
5. REMOVE FRONT DOOR SCUFF PLATE LH
6. REMOVE FRONT DOOR OPENING TRIM COVER LH
7. REMOVE INSTRUMENT SIDE PANEL LH
8. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
9. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY





10. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY
a. Remove the 2 screws.
b. Using a screwdriver, detach the 2 claws.

HINT: Tape the screwdriver tip before use.

c. Remove the control panel and then disconnect the connector.

INSTALLATION





1. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY
a. Connect the connector.
b. Attach the 2 claws to install the control panel.
c. Install the 2 screws.

2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
3. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
4. INSTALL INSTRUMENT SIDE PANEL LH
5. INSTALL FRONT DOOR OPENING TRIM COVER LH
6. INSTALL FRONT DOOR SCUFF PLATE LH
7. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
8. INSTALL CONSOLE UPPER PANEL ASSEMBLY
9. INSTALL FRONT CONSOLE UPPER PANEL GARNISH
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. PERFORM INITIALIZATION
a. Perform initialization.

NOTICE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

12. CHECK SRS WARNING LIGHT
a. Check the SRS warning light