Overhaul
DISASSEMBLY1. REMOVE SLIDING ROOF DRIVE GEAR ASSEMBLY
a. Detach the bracket's claw and remove the bracket.
b. Remove the 2 bolts and drive gear.
2. REMOVE SUNSHADE TRIM ASSEMBLY
a. Remove the 2 sliding roof panel stoppers and trim.
3. REMOVE SLIDING ROOF DRIVE CABLE ASSEMBLY
a. Only when replacing the sliding roof drive cable:
1. Remove the 2 screws and 2 sliding roof side stoppers.
2. Remove the screw and sliding roof piece LH.
3. Remove the screw and sliding roof piece RH.
4. Using a screwdriver, detach the 2 claw. Then slide the drip channel rearward to remove it.
HINT: Tape the screwdriver tip before use.
5. Using a screwdriver, slide the drive cable in the direction indicated by the arrow in the illustration to remove it.
HINT: Tape the screwdriver tip before use.
4. REMOVE ROOF WIND DEFLECTOR PANEL ASSEMBLY
a. Using a screwdriver, detach the 2 claws. Then remove the wind deflector panel.
HINT: Tape the screwdriver tip before use.
REASSEMBLY
1. INSTALL ROOF WIND DEFLECTOR PANEL ASSEMBLY
a. Attach the 2 claws and install the wind deflector panel.
2. INSTALL SLIDING ROOF DRIVE CABLE ASSEMBLY
a. Using a screwdriver, slide the drive cable in the direction indicated by the arrow in the illustration to install it.
HINT: Tape the screwdriver tip before use.
b. Attach the 2 claws and install the drip channel.
c. Install the sliding roof piece LH and RH with the 2 screws.
d. Install the 2 sliding roof side stoppers with the 2 screws.
3. ADJUST SLIDING ROOF DRIVE CABLE ASSEMBLY
a. Using a screwdriver, align the matchmarks by sliding the drive cable in the direction indicated by the arrow in the illustration.
HINT: Tape the screwdriver tip before use.
4. INSTALL SUNSHADE TRIM ASSEMBLY
5. INSTALL SLIDING ROOF DRIVE GEAR ASSEMBLY
a. Install the drive gear with the 2 bolts.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
b. Attach the bracket's claw to install the bracket.