Electronically Controlled Brake System

DTC C1336/98 Zero Point Calibration of Acceleration Sensor Undone

DESCRIPTION

DTC Detection Condition:

The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.

The yaw rate sensor has the built- in acceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2).

If there is trouble in the bus lines between the yaw rate and acceleration sensor and the CAN communication system, the DTCs U0123/62 (yaw rate sensor communication trouble) and U0124/95 (acceleration sensor communication trouble) are output.

The DTCs are also output when the calibration has not been completed.

Step 1:

Step 2-6:

Step 6(Continued):

INSPECTION PROCEDURE

NOTE: When replacing the skid control ECU, perform initialization of the linear solenoid valve and calibration. Initialization

HINT: When U0123/62, U0124/95 or U0126/63 is output along with C1210/36 or C1336/98, inspect and repair the trouble areas indicated by U0123/62, U0124/95 or U0126/63 first.