Steering Pad Switch Cable

Steering Pad Switch Cable:

STEERING PAD SWITCH CABLE

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE NO. 2 STEERING WHEEL COVER LOWER
3. REMOVE NO. 3 STEERING WHEEL COVER LOWER
4. REMOVE STEERING WHEEL PAD
5. REMOVE STEERING PAD SWITCH LH
6. REMOVE STEERING PAD SWITCH RH
7. REMOVE STEERING PAD SWITCH CABLE SUB-ASSEMBLY

INSTALLATION

1. INSTALL STEERING PAD SWITCH LH
2. INSTALL STEERING PAD SWITCH RH
3. INSTALL STEERING WHEEL PAD
4. INSTALL NO. 2 STEERING WHEEL COVER LOWER
5. INSTALL NO. 3 STEERING WHEEL COVER LOWER
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

8. CHECK SRS WARNING LIGHT
a. Check SRS warning light.