Central Control Module: Service and Repair

Network Gateway ECU:

NETWORK GATEWAY ECU

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH
3. REMOVE CONSOLE UPPER PANEL ASSEMBLY
4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH
5. REMOVE FRONT DOOR SCUFF PLATE RH
6. REMOVE FRONT DOOR OPENING TRIM COVER RH
7. REMOVE INSTRUMENT SIDE PANEL RH
8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
9. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
10. REMOVE GLOVE COMPARTMENT DOOR SUB-ASSEMBLY

11. REMOVE NETWORK GATEWAY ECU




a. Disconnect the connector.
b. Detach the 2 claws and remove the cover.
c. Remove the ECU.

INSTALLATION

1. INSTALL NETWORK GATEWAY ECU




a. Install the ECU.
b. Attach the 2 claws to install the cover.
c. Connect the connector.

2. INSTALL GLOVE COMPARTMENT DOOR SUB-ASSEMBLY
3. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
5. INSTALL INSTRUMENT SIDE PANEL RH
6. INSTALL FRONT DOOR OPENING TRIM COVER RH
7. INSTALL FRONT DOOR SCUFF PLATE RH
8. INSTALL INSTRUMENT PANEL FINISH PANEL END RH
9. INSTALL CONSOLE UPPER PANEL ASSEMBLY
10. INSTALL FRONT CONSOLE UPPER PANEL GARNISH
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

12. PERFORM INITIALIZATION
a. Perform initialization. Testing and Inspection

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

13. CHECK SRS WARNING LIGHT
a. Check SRS warning light.