Variable Valve Timing Actuator Position Sensor: Service and Repair
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE V-BANK COVER
3. REMOVE VVT SENSOR (for Intake Side of Bank 1)
a. Disconnect the sensor connector.
b. Remove the bolt and sensor.
4. REMOVE VVT SENSOR (for Exhaust Side of Bank 1)
a. Disconnect the sensor connector.
b. Remove the bolt and sensor.
5. REMOVE VVT SENSOR (for Intake Side of Bank 2)
a. Disconnect the sensor connector.
b. Remove the bolt and sensor.
6. REMOVE VVT SENSOR (for Exhaust Side of Bank 2)
a. Disconnect the sensor connector.
b. Remove the bolt and sensor.
INSTALLATION
1. INSTALL VVT SENSOR (for Exhaust Side of Bank 2)
a. Install the sensor with the bolt.
Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)
b. Connect the sensor connector.
2. INSTALL VVT SENSOR (for Intake Side of Bank 2)
a. Install the sensor with the bolt.
Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)
b. Connect the sensor connector.
3. INSTALL VVT SENSOR (for Exhaust Side of Bank 1)
a. Install the sensor with the bolt.
Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)
b. Connect the sensor connector.
4. INSTALL VVT SENSOR (for Intake Side of Bank 1)
a. Install the sensor with the bolt.
Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)
b. Connect the sensor connector.
5. INSTALL V-BANK COVER
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
7. PERFORM INITIALIZATION
a. Perform initialization
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.