B2242
DTC B2242 Steering Angle Mid-point Initial Setting IncompleteDESCRIPTION
DTC Detection Condition:
After replacing the clearance warning ECU, this DTC is output until the initial learning operation (steering angle mid-point and maximum steering angle range setting) is completed.
If this DTC is output, B2243 will also be output.
NOTE: When the clearance warning ECU is replaced, the initial learning operation (steering angle midpoint and maximum steering angle range setting) must be performed.
HINT: When replacing the ECU with another ECU, the ECU may not cause a DTC output if an initial learning operation was already performed on it.
INSPECTION PROCEDURE
Step 1:
