Front

FRONT AXLE HUB

ON-VEHICLE INSPECTION
1. REMOVE FRONT WHEEL
2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
3. REMOVE FRONT DISC





4. INSPECT FRONT AXLE HUB BEARING LOOSENESS
(a) Using a dial indicator, check for looseness near the center of the axle hub.
Maximum: 0.05 mm (0.0020 in.)

NOTICE: Ensure that the dial indicator is set perpendicular to the measurement surface.

HINT: If looseness exceeds the maximum, replace the bearing.





5. INSPECT FRONT AXLE HUB RUNOUT
(a) Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
Maximum: 0.05 mm (0.0020 in.)

NOTICE: Ensure that the dial indicator is set perpendicular to the measurement surface.

HINT: If runout exceeds the maximum, replace the axle hub.

6. INSTALL FRONT DISC
7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
8. INSTALL FRONT WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)