Rear Seat Side Airbag Assembly

Rear Seat Side Airbag Assembly:

REAR SEAT SIDE AIRBAG ASSEMBLY

REMOVAL

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

3. REMOVE REAR SEAT CUSHION ASSEMBLY
4. REMOVE REAR SEATBACK ASSEMBLY
5. REMOVE REAR DOOR SCUFF PLATE
6. REMOVE REAR SEAT SIDE AIRBAG ASSEMBLY




a. Disconnect the rear seat side airbag connector.

NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

b. Remove the 2 bolts.
c. Disengage the 4 claws and remove the rear seat side airbag assembly.

INSTALLATION

1. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY

a. Check that the engine switch is off.
b. Check that the battery negative (-) cable is disconnected.

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.




c. Engage the 4 claws.
d. Install the rear seat side airbag assembly with the 2 bolts.

Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)

e. Connect the rear seat side airbag connector.

NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL REAR DOOR SCUFF PLATE
3. INSTALL REAR SEATBACK ASSEMBLY
4. INSTALL REAR SEAT CUSHION ASSEMBLY
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. PERFORM INITIALIZATION
a. Perform initialization.

HINT: Some systems need initialization after reconnecting the cable to the negative battery terminal.

7. INSPECT REAR SEAT SIDE AIRBAG ASSEMBLY

8. INSPECT SRS WARNING LIGHT
a. Inspect the SRS warning light