Front Side Speaker

ON-VEHICLE INSPECTION

1. INSPECT FRONT NO. 1 SPEAKER

HINT: Remove interior parts so that the front No. 1 speaker can be seen.

a. Check the speaker installation.

OK: The speaker is securely installed.

If the result is not as specified, reinstall the front No. 1 speaker.

b. Visually check the speaker.

OK: The cone paper of the speaker is not torn. If the result is not as specified, replace the front No. 1 speaker.

c. Speaker resistance check
1. Disconnect the front No. 1 speaker connector.
2. Measure the resistance between the terminals of the speaker.

Standard resistance: Approximately 4 Ohm

If the result is not as specified, replace the front No. 1 speaker.

2. INSPECT FRONT NO. 2 SPEAKER

HINT: Remove interior parts so that the front No. 2 speaker can be seen.

a. Check the speaker installation.

OK: The speaker is securely installed.

If the result is not as specified, reinstall the front No. 2 speaker.

b. Visually check the speaker.

OK: The cone paper of the speaker is not torn.

If the result is not as specified, replace the front No. 2 speaker.