Rear
REPLACEMENT1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR LH
a. Disconnect the connector.
b. Place matchmarks on the link and bracket.
c. Remove the nut and disconnect the sensor link.
d. Remove the 2 bolts and sensor.
3. INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR LH
a. Install the sensor with the 2 bolts.
Torque: 7.8 N.m (80 kgf.cm, 69 in.lbf)
b. Align the matchmarks on the sensor link and bracket.
c. Install the nut.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
d. Connect the connector.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
6. ADJUST HEADLAMP AIMING