Camshaft Position Sensor: Service and Repair

Camshaft Position Sensor:

REPLACEMENT

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. DRAIN ENGINE COOLANT

3. REMOVE V-BANK COVER

a. Remove the 2 nuts and V-bank cover.

4. REMOVE RADIATOR HOSE NO.1
5. REMOVE TIMING BELT COVER SUB-ASSEMBLY NO.3 LH

6. REMOVE CAMSHAFT POSITION SENSOR




a. Remove the bolt, stud bolt and sensor.

7. INSTALL CAMSHAFT POSITION SENSOR

a. Install a new sensor with the bolt and stud bolt.

Torque: 7.5 N.m (76 kgf.cm, 66 in.lbf)

8. INSTALL TIMING BELT COVER SUB-ASSEMBLY NO.3 LH
9. INSTALL RADIATOR HOSE NO.1

10. INSTALL V-BANK COVER

a. Install the V-bank cover with the 2 nuts.

Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf)

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
12. PERFORM INITIALIZATION

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

13. ADD ENGINE COOLANT
14. CHECK FOR ENGINE COOLANT LEAKS