Trunk / Liftgate Lock: Service and Repair

Luggage Compartment Door Lock:

REPLACEMENT

HINT:
- The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.
- A bolt without a torque specification is shown in the standard bolt chart.




1. REMOVE REAR FLOOR FINISH PLATE
a. Using a screwdriver, detach the 4 clips and remove the rear floor finish plate.

HINT: Tape the screwdriver tip before use.

2. REMOVE SPARE WHEEL COVER ASSEMBLY
3. REMOVE SPARE DISC WHEEL
4. REMOVE LUGGAGE COMPARTMENT FLOOR MAT




5. REMOVE LUGGAGE COMPARTMENT TRIM COVER RH
a. Using a clip remover, remove the 3 clips.
b. Remove the trim cover.

6. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH
a. Using a clip remover, remove the 3 clips.
b. Remove the trim cover.

7. REMOVE TOOL BOX COVER
a. Remove the 4 nuts and cover.




8. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY
a. Remove the bolt, and striker LH and RH.




9. REMOVE LUGGAGE COMPARTMENT TRIM COVER SUB-ASSEMBLY REAR
a. Using a clip remover, remove the 4 clips and trim cover.




10. REMOVE SPARE WHEEL CARRIER BRACKET
a. Remove the 4 bolts and carrier bracket.




11. REMOVE LUGGAGE DOOR LOCK CONTROL CABLE SUB-ASSEMBLY
a. Remove the 2 nuts and cable bracket.
b. Remove the clip, and then disconnect the luggage door lock control cable.
c. Using a clip remover, disconnect the clamp of the cable.




12. REMOVE LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY
a. Remove the 2 nuts.
b. Remove the lock and lift it upward. Move the hinge to the position where the door is in the fully open condition from the front, and disconnect the luggage opener cable.

NOTE: Be careful not to pull up the cable forcibly.

c. Remove the luggage compartment door lock.




13. INSTALL LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY
a. Install the lock with the 2 nuts.

Torque: 21 N.m (214 kgf.cm, 15 in.lbf)




14. INSTALL LUGGAGE DOOR LOCK CONTROL CABLE SUB-ASSEMBLY
a. Install the cable. Then install the clip to the cable.
b. Install the bracket with the 2 nuts.
c. Install the cable to the vehicle body with the clamp.

Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)




15. INSTALL SPARE WHEEL CARRIER BRACKET
a. Install the bracket with the 4 bolts.

Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)




16. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY
a. Install the striker LH and RH with the 2 bolts.

Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)