Steering Column - Electric Steering Lock

PRECAUTION





1. NOTICE FOR INITIALIZATION:

NOTICE: When disconnecting the negative battery cable, initialize the following systems after the cable is reconnected.

2. PRECAUTIONS WHEN WORKING ON ELECTRIC STEERING LOCK
a) After replacing the steering lock actuator assembly (steering lock ECU), perform the code registration.
b) If the steering lock actuator assembly is replaced, open and close the driver's door. The engine may not start until either operation is performed.

HINT: Opening and closing the driver's door causes the steering lock actuator assembly (steering lock ECU) to memorize the correct steering lock bar position.

c) If checking for DTCs of the push button start function or checking the DATA LIST with the engine switch off, make sure that the driver's door is open.

HINT: When the engine switch is off, the main body ECU RH (cowl side J/B RH) may be in a sleep mode. If the main body ECU RH (cowl side J/B RH) is in this sleep mode, it will not be possible for the intelligent tester to communicate with it.