Front Side Speaker

ON-VEHICLE INSPECTION

1. INSPECT FRONT NO.1 SPEAKER

HINT: Remove interior parts so that the front No.1 speaker can be seen.

a. Check the speaker installation.
OK:
The speaker is securely installed. If the result is not as specified, reinstall the front No.1 speaker.

b. Visually check the speaker.
OK:
The cone paper of the speaker is not torn. If the result is not as specified, replace the front No.1 speaker.

c. Speaker resistance check
1. Disconnect the front No.1 speaker connector.
2. Measure the resistance between the terminals of the speaker.

Standard resistance:
Without Front Center Speaker: Approximately 4 Ohms
With Front Center Speaker: 6 to 10 Ohms

If the result is not as specified, replace the front No.1 speaker.

2. INSPECT FRONT NO.2 SPEAKER

HINT: Remove interior parts so that the front No.2 speaker can be seen.

a. Check the speaker installation.
OK:
The speaker is securely installed.

If the result is not as specified, reinstall the front No.2 speaker.

b. Visually check the speaker.
OK:
The cone paper of the speaker is not torn.

If the result is not as specified, replace the front No.2 speaker.

3. INSPECT FRONT NO.3 SPEAKER

HINT: Remove interior parts so that the front No.3 speaker can be seen.

a. Check the speaker installation.
OK:
The speaker is securely installed.

If the result is not as specified, reinstall the front No.3 speaker.

b. Visually check the speaker.
OK:
The cone paper of the speaker is not torn.

If the result is not as specified, replace the front No.3 speaker.