Repair Procedure: Reassembly Steps 37 - 43

37. Install the V-bank cover sub-assembly.
Engage the 2 clips on the front of the cover, and then engage the clip on the rear to install the V-bank cover.

NOTE
- Be sure to engage the clips securely.
- Do NOT apply excessive force or hit the cover to engage the clips. This may cause the cover to break.






38. Install the engine compartment side cover LH with the 5 clips.






39. Install the engine compartment side cover RH with the 2 clips.






40. Install the cool air intake duct seal with the 11 clips.






41. Check throttle body function and throttle control motor operating sounds.
A. Turn the engine switch ON (IG).
B. When pressing the accelerator pedal, check the operating sound of the running motor. Make sure that NO friction noises emit from the motor. If friction noise exists, replace the throttle body.

42. Re-initialize the power windows on the vehicle.
Refer to TSB No. 2174, "Initialization of Power Window During PDS."

43. Complete TSB No. 2804, "MIL "ON" DTC P030# and/or Intermittently Runs Rough". This will complete the repair.

NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.