Vehicle Stability Control System (w/o VDIM)

DTC C1235/35 Foreign Object is Attached on Tip of Front Speed Sensor RH
DTC C1236/36 Foreign Object is Attached on Tip of Front Speed Sensor LH
DTC C1238/38 Foreign Object is Attached on Tip of Rear Speed Sensor RH
DTC C1239/39 Foreign Object is Attached on Tip of Rear Speed Sensor LH
DTC C1275/75 Abnormal Change in Output Signal of Front Speed Sensor RH (Test Mode DTC)
DTC C1276/76 Abnormal Change in Output Signal of Front Speed Sensor LH (Test Mode DTC)
DTC C1277/77 Abnormal Change in Output Signal of Rear Speed Sensor RH (Test Mode DTC)
DTC C1278/78 Abnormal Change in Output Signal of Rear Speed Sensor LH (Test Mode DTC)

DESCRIPTION





The speed sensor detects wheel speed and sends the appropriate signals to the skid control ECU. These signals are used for the ABS control system. This speed sensor contains a sensor IC, which consists of 2 MREs (Magnetic Resistance Element). The speed sensor rotor, which consists of 48 sets of N and S poles that are arranged in a circle, is integrated with the inner race of the hub bearing.

To detect the rotation direction, the output waves are used to determine the relationship of the pulses that are generated by 2 MREs. Upon receiving this signal, the sensor IC outputs a forward or backward wave to the ECU.

DTCs C1275/75 to C1278/78 can be deleted when the speed sensor sends a vehicle speed signal or the Test Mode ends. DTCs C1275/75 to C1278/78 are output only in the Test Mode.

DTC DETECTION CONDITION:

HINT:
^ DTC C1235/35 is for the front speed sensor RH.
^ DTC C1236/36 is for the front speed sensor LH.
^ DTC C1238/38 is for the rear speed sensor RH.
^ DTC C1239/39 is for the rear speed sensor LH.

WIRING DIAGRAM:

WIRING DIAGRAM:

NOTICE: When replacing the brake actuator assembly, perform zero point calibration. Vehicle Stability Control System (W/O VDIM)

HINT: When C0200/31, C0205/32, C0210/33, or C0215/34 is output together with C1235/35, C1236/36, C1238/38, or C1239/39, inspect and repair the trouble areas indicated by C0200/31, C0205/32, C0210/33, or C0215/34 first.

INSPECTION PROCEDURE

Step 1:

Steps 2-4:

Steps 4 (Continued)-7:

Steps 7 (Continued)-8: