Cylinder Head Assembly: Specifications
CYLINDER HEADLH Bank:
RH Bank:
Install and uniformly tighten the 10 cylinder head bolts and plate washers in the sequence shown in the illustration.
Torque 59 Nm (601 kgf-cm, 44 ft. lbs.)
Mark the front of the cylinder head bolt's head with paint.
Retighten the cylinder head bolts by 90° in the sequence shown in the illustration.
Check that the painted mark is now at a 90° angle to the front.
Cylinder head
Cylinder block side: Maximum warpage 0.05 mm (0.0020 in.)
Intake manifold side: Maximum warpage 0.10 mm (0.0039 in.)
Exhaust manifold side: Maximum warpage 0.10 mm (0.0039 in.)
INTAKE MANIFOLD 18 Nm (184 kgf-cm, 13 ft. lbs.)
CAMSHAFT BEARING CAP
Uniformly tighten the 22 bearing cap bolts in several passes in the sequence shown in the illustration.
Torque 7.5 Nm (76 kgf-cm, 66 ft. lbs.) for bolts 21 and 22
Torque 16 Nm (163 kgf-cm, 12 inch lbs.) for other bolts
EXHAUST MANIFOLD 44 Nm (449 kgf-cm, (66 inch lbs.)