Calibration

CALIBRATION

NOTICE: Use this procedure to center the steering wheel if:
^ The steering actuator has been replaced,
^ The steering control ECU has been replaced,
^ The steering column or gear has been disconnected, or
^ The steering wheel is still off-center after completing the steering angle sensor initialization.

1. VGRS SYSTEM CALIBRATION PROCEDURE (USING SST CHECK WIRE)

Steps 1 - 3:

Step 3 (Continued) - 6:

Step 6 (Continued) - 8:

Step 8 (Continued) - 10:

2. VGRS SYSTEM CALIBRATION PROCEDURE (USING INTELLIGENT TESTER)

Steps 1 - 2:

Step 2 (Continued):

Step 2 (Continued) - 3:

Step 4: