Crankshaft Position Sensor: Service and Repair
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE COOL AIR INTAKE DUCT SEAL
3. REMOVE ENGINE ROOM SIDE COVER RH
4. REMOVE ENGINE ROOM SIDE COVER LH
5. REMOVE NO. 1 AIR CLEANER INLET
a. Remove the bolt and air cleaner inlet.
6. REMOVE V-BANK COVER
a. Remove the 2 nuts and V-bank cover.
7. REMOVE FAN AND GENERATOR V-BELT
8. REMOVE ENGINE UNDER COVER
a. Using a clip remover, remove the 3 clips.
b. Remove the 10 screws and under cover.
9. DISCONNECT COMPRESSOR WITH PULLEY ASSEMBLY
10. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the sensor connector.
b. Remove the bolt and sensor.
INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR
a. Apply a coat of engine oil to an O-ring of the sensor.
b. Install the sensor with the bolt.
Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)
c. Connect the sensor connector.
2. INSTALL COMPRESSOR WITH PULLEY ASSEMBLY
3. INSTALL ENGINE UNDER COVER
a. Install the under cover with the 10 bolts and 3 clips.
4. INSTALL FAN AND GENERATOR V-BELT
5. INSTALL V-BANK COVER
a. Install the V-bank cover with the 2 nuts.
Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf)
6. INSTALL NO. 1 AIR CLEANER INLET
a. Install the air cleaner inlet with the bolt.
Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf)
7. INSTALL ENGINE ROOM SIDE COVER LH
8. INSTALL ENGINE ROOM SIDE COVER RH
9. INSTALL COOL AIR INTAKE DUCT SEAL
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.