Rear

REAR AXLE HUB

COMPONENTS:

COMPONENTS:

ON-VEHICLE INSPECTION
1. REMOVE REAR WHEEL
2. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY
3. REMOVE REAR DISC





4. INSPECT REAR AXLE HUB BEARING LOOSENESS
a. Using a dial indicator, check for looseness near the center of the axle hub.
Maximum: 0.05 mm (0.0020 inch)

NOTICE: Ensure that the dial indicator is set at right angles to the measurement surface. If looseness exceeds the maximum, replace the axle hub assembly.





5. INSPECT REAR AXLE HUB RUNOUT
a. Using a dial indicator, check for runout on surface of the axle hub outside the hub bolt.
Maximum: 0.05 mm (0.0020 inch)

NOTICE: Ensure that the dial indicator is set at right angles to the measurement surface. If runout exceeds the maximum, replace the axle hub assembly.

6. INSTALL REAR DISC
7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
8. INSTALL REAR WHEEL