Cylinder Head Assembly: Specifications

CYLINDER HEAD

Right Bank

Left Bank

Install and uniformly tighten the 10 cylinder head bolts, and plate washers in the sequence shown in the illustration.
Torque 36 Nm (367 kgf-cm, 27 ft. lbs.)

Second pass 90°

Third pass 90°

INTAKE MANIFOLD
Install a new gasket and the intake manifold with the 4 bolts and 2 nuts.
Torque: 21 Nm (214 kgf-cm 15 ft. lbs.)

CAMSHAFT BEARING CAP RH
Apply engine oil to the camshaft journal, camshaft housing and bearing cap.
Install the camshaft and camshaft No.2 to the camshaft housing RH.
Make sure of the marks and numbers on the camshaft bearing caps and place them in each proper position and direction.

Temporarily tighten the 8 bolts in the order shown in the illustration.
Torque: 10 Nm (102 kgf-cm 7 ft. lbs.)

CAMSHAFT BEARING CAP LH
Apply engine oil to the camshaft journal, camshaft housing and bearing cap.
Install the camshaft No.3 and camshaft No.4 to the camshaft housing LH.
Make sure of the marks and numbers on the camshaft bearing caps and place them in each proper position and direction.

Temporarily tighten the 8 bolts in the order shown in the illustration.
Torque 10 Nm (102 kgf-cm 7 ft. lbs.)

CRANKSHAFT PULLEY
Align the pulley set key with the key groove of the pulley, and slide on the pulley.
Using SST, install the pulley bolt.
SST 09213-70011 (09213-70020), 09330-00021
Torque 250 Nm (2,550 kgf-cm 184 ft. lbs.)

EXHAUST MANIFOLD SUB-ASSEMBLY RH

Install a new gasket as shown in the illustration.

Install the exhaust manifold with the 6 nuts.
Torque 21 Nm (214 kgf-cm 15 ft. lbs.)

NOTICE: Do not damage the stud bolt when installing the exhaust manifold.

HINT: First tighten either of the 2 nuts indicated by the arrows in the illustration.

EXHAUST MANIFOLD SUB-ASSEMBLY LH

Install a new gasket as shown in the illustration.