Clearing Diagnostic Trouble Codes
DTC CLEARDTC CLEAR (WHEN USING INTELLIGENT TESTER:)
1. Connect the intelligent tester to the DLC3.
2. Turn the engine switch on (IG).
3. Operate the intelligent tester to clear the codes.
DTC CLEAR (WHEN USING SST CHECK WIRE:)
1. Using SST, connect terminals TC and CG of the DLC3.
SST 09843-18040
2. Turn the engine switch on (IG).
3. Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.
4. Check that the multi information display indicates the normal system code.
5. Remove the SST from the terminals of the DLC3.
HINT: Clearing the DTCs cannot be performed by removing the battery cable or the ECU-IG fuse.
END OF DTC CHECK/CLEAR
a. Turn the engine switch on (IG).
b. Check that the ABS warning light goes off within approximately 3 seconds.