Without Scan Tool

CLEAR/RECHECK DTC

HINT: Illustrations may differ from the actual vehicle depending on the device settings and options.

Start diagnostic mode

Clear DTC.




1. Press Code CLR for 3 seconds.
2. DTC is cleared.

Recheck DTC




1. Press Recheck.




2. Confirm that all diagnostic codes are "OK" when the check results are displayed. If a code other than "OK" is displayed, perform troubleshooting again.




3. Press LAN Mon to change to the "LAN Monitor" screen.




4. Confirm that all diagnostic codes are "No Err". If a code other than "No Err" is displayed, perform troubleshooting again.