DTC 23
DTC C2121/21 No Signal from Transmitter ID1 in Main ModeDTC C2122/22 No Signal from Transmitter ID2 in Main Mode
DTC C2123/23 No Signal from Transmitter ID3 in Main Mode
DTC C2124/24 No Signal from Transmitter ID4 in Main Mode
DTC C2131/31 No Signal from Transmitter ID1 in 2nd Mode
DTC C2132/32 No Signal from Transmitter ID2 in 2nd Mode
DTC C2133/33 No Signal from Transmitter ID3 in 2nd Mode
DTC C2134/34 No Signal from Transmitter ID4 in 2nd Mode
DTC C2181/81 Transmitter ID1 not Received (Test Mode DTC)
DTC C2182/82 Transmitter ID2 not Received (Test Mode DTC)
DTC C2183/83 Transmitter ID3 not Received (Test Mode DTC)
DTC C2184/84 Transmitter ID4 not Received (Test Mode DTC)
DESCRIPTION
The tire pressure monitor valve sub-assembly constantly sends radio waves to the tire pressure monitor receiver assembly. If the battery for the tire pressure monitor valve sub-assembly is depleted, or if the tire pressure monitor receiver assembly is defective or comes off, the DTC will be output. DTCs C2121/21 to C2124/24 and C2131/31 to C2134/34 can only be deleted by the tester. DTCs C2181/81 to C2184/84 can be deleted when the transmitter sends a force transmission signal or the test mode ends. DTCs C2181/81 to C2184/84 are output only in the test mode.
DTC DETECTION CONDITION:
HINT: It is necessary to perform the procedure to identify the tire pressure monitor valve sub-assembly that is malfunctioning because it cannot be identified by the output DTC.
WIRING DIAGRAM:
NOTICE: It is necessary to register an ID code after replacing the tire pressure monitor valve sub-assembly and/or the tire pressure monitor ECU.
HINT: Set the tire pressure to the specified value.
INSPECTION PROCEDURE
Steps 1-5:
Steps 6-8:
Step 8 (Continued)-9:
Steps 10-11:
Step 11 (Continued)-14:
Steps 15-16:
Step 16 (Continued)-17:
Steps 18-21:
Steps 22-24:
