DTC 01-D5

DTC 01-D5 Absence of Registration Unit (EMV)
DTC 01-D8 No Response for Connection Check (EMV)
DTC 01-D9 Last Mode Error (EMV)
DTC 01-DA No Response Against ON / OFF Command (EMV)
DTC 01-DB Mode Status Error (EMV)
DTC 01-DC Failure in Transmission (EMV)
DTC 01-DE Slave Reset (EMV)

DTC Detection Condition:

DESCRIPTION

HINT:
- *1: This code may be recorded depending on the battery condition or engine start voltage even if no failure is detected.
- *2: If the power connector is disconnected after the engine starts, this code is recorded after 180 seconds.
- *3: This code may be stored if the engine is started, idled for 60 seconds, turned off, and then started again.
- *4: This code may be stored if the engine is started, turned off, and then started again.
- *5: If the device is reported as not existing during verification, check the power source circuit and AVCLAN circuit for the device.

Step 1-2:

Step 3:

INSPECTION PROCEDURE