Engine Control Module: Service and Repair

REPLACEMENT

1. DISCONNECT ENGINE WIRE NO. 3 (BATTERY NEGATIVE TERMINAL)
2. REMOVE FRONT DOOR SCUFF PLATE RH
3. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSY NO.1
4. REMOVE INSTRUMENT PANEL SUB-ASSY LOWER
5. REMOVE STEREO COMPONENT AMPLIFIER ASSY




a. Disconnect the 3 stereo component amplifier connectors.
b. Remove the 2 nuts, then remove the stereo component amplifier.

6. REMOVE ECM




a. Remove the wire harness clamp.
b. Disconnect the 5 ECM connectors.
c. Remove the 2 nuts, then remove the ECM.

7. REMOVE ECM BRACKET




a. Remove the 2 screws, then remove the ECM bracket.

8. REMOVE ECM BRACKET NO.2




a. Remove the 2 screws, then remove the ECM bracket No. 2.

9. REMOVE ECM BRACKET NO.3




a. Remove the 2 screws, then remove the ECM bracket No 3.

10. INSTALL ECM BRACKET NO.3
11. INSTALL ECM BRACKET NO.2
12. INSTALL ECM BRACKET
13. INSTALL ECM

Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)

14. INSTALL STEREO COMPONENT AMPLIFIER ASSY

Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)

15. INSTALL INSTRUMENT PANEL SUB-ASSY LOWER
16. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSY NO.1
17. INSTALL FRONT DOOR SCUFF PLATE RH
18. CONNECT ENGINE WIRE NO. 3 (BATTERY NEGATIVE TERMINAL)

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)

19. RESET MEMORY
20. SYSTEM INITIALIZATION