DTC 12

DTC C0279/12 SHORT CIRCUIT IN ABS SOLENOID RELAY CIRCUIT

CIRCUIT DESCRIPTION

DTC Detection Condition:

This relay supplies power to each ABS solenoid. After the ignition switch is turned ON, if the initial check is OK, the relay turns on.

*1 Solenoid relay contact ON condition:
All of solenoid terminal voltage is half of IG terminal voltage or more.

*2 Solenoid relay contact OFF condition:
All of solenoid terminal voltage is half of IG terminal voltage or less than.

Wiring Diagram:

Step 1-2:

INSPECTION PROCEDURE

HINT: Start the inspection from step 1 in case of using the hand-held tester and start from step 2 in case of not using the hand-held tester.