Turn Signal Switch: Service and Repair

Turn Signal Switch Assy:

REPLACEMENT

HINT: The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
3. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY NO.1
4. REMOVE STEERING COLUMN COVER LOWER
5. REMOVE STEERING COLUMN COVER UPPER




6. REMOVE TURN SIGNAL SWITCH ASSEMBLY
a. Disconnect the connector.
b. Remove the 2 screws and switch.

7. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. PERFORM INITIALIZATION

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative(-) battery terminal.

10. CHECK SRS WARNING LAMP