Back Window Frame Sub-Assy Upper

Back Window Frame Sub-Assy Upper:

OVERHAUL

HINT: A bolt without a torque specification is shown in the standard bolt chart.




1. HALF OPEN ROOF PANEL
a. Refer to the MANUAL OPERATING procedures and half open the roof.




2. REMOVE ROOF SIDE GARNISH INNER RH
a. Using a clip remover, remove the clip A.
b. Using a screwdriver, detach the 7 clips.

HINT: Tape the screwdriver tip before use.

c. Remove the side garnish.

3. REMOVE ROOF SIDE GARNISH INNER LH

HINT: Use the same procedures described for the RH side.




4. REMOVE ROOF HEADLINING ASSEMBLY REAR
a. Using a screwdriver, detach the 7 clips.

HINT: Tape the screwdriver tip before use.

b. Remove the roof headlining.




5. REMOVE BACK WINDOW FRAME SUB-ASSEMBLY UPPER
a. Using a T40 torx(R) socket, remove the 8 screws.
b. Remove the back window frame.




6. REMOVE REMOVABLE ROOF WEATHERSTRIP REAR
a. Remove the 4 screws, 2 nuts and 4 clips.
b. Using a clip remover, detach the clips.
c. Remove the removable roof weatherstrip rear.




7. REMOVE ROOF SIDE RAIL WEATHERSTRIP RETAINER RH
a. Remove the 4 screws and weatherstrip retainer.

8. REMOVE ROOF SIDE RAIL WEATHERSTRIP RETAINER

HINT: Use the same procedures described for the RH side.

9. REMOVE BACK WINDOW OUTSIDE MOULDING
10. REMOVE BACK WINDOW GLASS
11. CLEAN BACK WINDOW GLASS
12. INSTALL BACK WINDOW GLASS ADHESIVE DAM
13. INSTALL BACK WINDOW GLASS
14. INSTALL ROOF SIDE RAIL WEATHERSTRIP RETAINER LH
15. INSTALL ROOF SIDE RAIL WEATHERSTRIP RETAINER RH
16. INSTALL REMOVABLE ROOF WEATHERSTRIP REAR
17. INSTALL BACK WINDOW FRAME SUB-ASSEMBLY UPPER

Torque: 40 N.m (408 kgf.cm, 30 ft.lbf)

18. INSTALL ROOF HEADLINING ASSEMBLY REAR
19. INSTALL ROOF SIDE GARNISH INNER LH
20. INSTALL ROOF SIDE GARNISH INNER RH
21. INSPECT FOR LEAKS AND REPAIR