Removal and Replacement

HOOD SUPPORT

REPLACEMENT

HINT:
- the same procedures for the RH side and LH side.
- The procedures listed are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart.





1. REMOVE HOOD SUPPORT ASSEMBLY LH
a. Remove the bolt and hood support from the hood panel.

HINT: While supporting the hood by hand, remove the hood support.

b. Remove the bolt and hood support from the body.

2. INSTALL HOOD SUPPORT ASSEMBLY LH
a. Install the hood support with the 2 bolts.

Torque: 22 N.m (224 kgf.cm, 16 ft.lbf)