Front No.1 Speaker Assy

Front No.1 Speaker Assy:

REPLACEMENT

HINT:
- The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
3. REMOVE DOOR INSIDE HANDLE BEZEL NO.2 LH
4. REMOVE FRONT DOOR WINDOW UPPER BRACKET GARNISH LH
5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH




6. REMOVE FRONT NO.1 SPEAKER ASSEMBLY LH
a. Disconnect the connector.
b. Remove the bolt and speaker.

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. PERFORM INITIALIZATION

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.