Seat Position Sensor
REPLACEMENTHINT: Installation is in the reverse order of removal.
1. PRECAUTION
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE FRONT SEAT ASSEMBLY LH
4. REMOVE SEAT POSITION AIR BAG SENSOR
a. Disconnect the connector from the seat position airbag sensor.
b. Remove the bolt and the seat position airbag sensor.
5. INSTALL SEAT POSITION AIR BAG SENSOR
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.
CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.
c. Install the seat position airbag sensor with the bolt.
Torque: 10 Nm (102 kgf.cm, 7 ft.lbf)
NOTE:
- If the seat position airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the seat position airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
d. Connect the connector to the seat position airbag sensor.
e. Check that there is no looseness in the installation parts of the seat position airbag sensor.
6. INSTALL FRONT SEAT ASSEMBLY LH
7. CONNECT BATTERY NEGATIVE TERMINAL
NOTE: When disconnecting the negative (-) battery terminal, initialize the system shown in the table after the terminal is reconnected.
8. INSPECT SRS WARNING LIGHT