Fog/Driving Lamp: Service and Repair
FOG LAMP ASSEMBLYOVERHAUL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- Reassembly is in the reverse order of overhaul.
1. REMOVE ENGINE UNDER COVER NO.1
2. REMOVE FRONT FENDER LINER LH
3. REMOVE FRONT FENDER LINER RH
4. REMOVE FRONT BUMPER COVER
5. REMOVE FOG LAMP ASSEMBLY LH
a. Remove the bolt from the fog lamp assembly LH.
b. Release the 2 claw fittings, then pull out the fog lamp assembly LH.
6. REMOVE FOG LAMP BULB
a. Remove the fog lamp bulb from the fog lamp assembly LH as shown in the illustration.
7. INSTALL FRONT BUMPER COVER
8. INSTALL FRONT FENDER LINER LH
9. INSTALL FRONT FENDER LINER RH
10. INSTALL ENGINE UNDER COVER NO.1
11. PUT VEHICLE UNDER THESE CONDITIONS
12. ADJUST FOG LIGHT AIM