Cruise Control System

PRECAUTION

NOTE: When disconnecting the negative (-) battery terminal, initialize the following system(s) after the terminal is reconnected.
- Front Power Seat Control System

Initialize Front Power Seat Control System
a. The power seat ECU must be initialized under any of the following conditions.
- The battery is disconnected.
- The D/C cut fuse is replaced.
- The power seat switch (power seat ECU) is replaced.
- The power seat assembly is removed from the vehicle.

b. Initialize the power seat ECU as follows.
1. Using the seat switches, fully slide the seat forward, fully recline the seatback forward, and fully raise the seat cushion and headrest.
2. Using the seat switches, fully slide the seat rearward, fully recline the seatback rearward, and fully lower the seat cushion and headrest.


Pay attention to the following points when inspecting the cruise control system.

a. Push the cruise control main switch ON-OFF button off when not using the cruise control.
b. Be careful of vehicle speed increase when driving downhill with the cruise control on.
c. RESUME/ACCEL operation, after canceling the cruise control, works as RESUME, and works as ACCEL while the cruise control system is in operation.
d. Push the cruise control main switch ON-OFF button off and reset the cruise control if the CRUISE main indicator light blinks while the cruise control system is in operation. When the cruise control cannot be set by this procedure or cancelled immediately after setting, there may be a malfunction in the system.
e. Do not use the cruise control system where the road conditions are as follows:
- Heavy traffic
- Steep downhill
- Sharp turns
- Icy or snowy roads
- Slippery roads