C1713

DTC C1713 RIGHT REAR HEIGHT CONTROL SENSOR CIRCUIT

CIRCUIT DESCRIPTION

DTC Detecting Condition:

The height control sensor sub-assembly controls the resistance value by following changes in vehicle height. The suspension control ECU detects the change in vehicle height from the transformed voltage. The suspension control ECU outputs a constant voltage of 5 V to the SHB terminal of the height control sensor sub-assembly.

In the height control sensor, the voltage is changed due to resistance. The changed voltage is output from the SHFR terminal of the height control sensor sub-assembly to suspension control ECU, thus the vehicle height is detected.

HINT:
- If DTC C1711, C1712, C1713 or C1714 is output, vehicle height control is suspended.
- If the normal signal is output from the height control sensor sub-assembly while suspending vehicle height control, vehicle height control is resumed. The operation is also resumed when the ignition switch is turned off once, then turned on again.

Wiring Diagram:

Step 1 - 2:

Step 3:

Step 4:

Step 4 (Continued) - 5:

Step 5 (Continued):

Step 6:

Step 7:

Step 7 (Continued) - 8:

Step 8 (Continued):

INSPECTION PROCEDURE

HINT: Proceed to troubleshooting following the flow chart, regardless of whether or not DTC C1711, C1712, C1713 or C1714 is displayed.