Power Window Control System

Connector disconnected:
INSPECT POWER WINDOW MASTER SWITCH CIRCUIT
Disconnect the connectors from the switch and inspect connector on the wire harness side.
If circuit is not as specified, replace the switch.

INSPECT POWER WINDOW MASTER SWITCH CIRCUIT







INSPECT POWER WINDOW SWITCH CONTINUITY
Connect the positive (+) lead from the battery to terminal 3 and the negative (-) lead to terminal 6.
If continuity is not as specified, replace the switch.

INSPECT POWER WINDOW SWITCH CIRCUIT

INSPECT JAM PROTECTION FUNCTION

NOTE: Never, ever be caught any part of your body when checking.

HINT: In case of performing resetting of the limit switch, do checking after repeating up and down of the glass with automatic operation.

a. Confirmation of AUTO up operation:
Confirm that the window will be fully close with AUTO up operation.

b. Checking of the operation of the jam protection function:
1. Move up the window with AUTO up operation and check that the window will go down when it touches the handle of the hammer stetted.
2. Confirm that the window will then stop going down about 200 mm.

HINT: In case of removing the glass, glass guide, regulator and etc. be sure to perform checking of the jam protection function. If the jam protection is not functioned properly, adjust power window motor reset switch and pulse switch.