Hydraulic Control Assembly - Antilock Brakes: Service and Repair

REMOVAL
1. REMOVE AIR CLEANER INLET AND AIR CLEANER
2. DISCONNECT BRAKE LINES
Using SST, disconnect the 6 brake lines from the ABS & TRAC/VSC actuator.
SST 09023-00100
Torque: 15 Nm (155 kgf-cm, 11 ft. lbs.)
3. DISCONNECT BRAKE HOSE AND CONNECTOR
4. REMOVE ABS & TRAC/VSC ACTUATOR ASSEMBLY
Remove the nut, 2 bolts and ABS & TRAC/VSC actuator assembly.
Torque: 19 Nm (195 kgf-cm, 14 ft. lbs.)
5. REMOVE ABS & TRAC & VSC ACTUATOR
a. Remove the 2 nuts and ABS & TRAC/VSC actuator from the bracket.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
b. Remove the 2 cushion bolts and 3 cushions.

INSTALLATION
Installation is In the reverse order of removal.

HINT: After installation, fill the brake reservoir with brake fluid, bleed brake system. Check for leaks.