Removal and Installation

REMOVAL
1. REMOVE ENGINE UNDER COVER
Remove the 16 bolts and engine under cover.
2. REMOVE RH REAR ENGINE UNDER COVER
Remove the 2 bolts and PH rear engine under cover.
3. REMOVE AIR CLEANER INLET
Remove the bolt and air cleaner inlet.
4. REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
a. Disconnect the MAP meter connector.
b. Remove the clamp.
c. Remove the 3 bolts and air cleaner assembly with air cleaner hose.





5. REMOVE DRIVE BELT
Loosen the drive belt tension by turning the drive belt tensioner counterclockwise, and remove the drive belt.
6. DISCONNECT 2 VACUUM HOSES
Remove the 2 clips and 2 vacuum horses.
7. DISCONNECT RETURN HOSE
Remove the clip and disconnect the return hose.
8. REMOVE PRESSURE FEED TUBE
Remove the union bolt, gasket and pressure feed tube.
9. REMOVE PS VANE PUMP ASSEMBLY
Remove the 2 bolts, nut and PS vane pump assembly.

INSTALLATION
1. INSTALL PS VANE PUMP ASSEMBLY
a. Install the PS vane pump assembly with the nut.
Torque: 43 Nm (440 kgf-cm, 32 ft. lbs.)
b. Install the 2 bolts.
Torque: 39 Nm (400 kgf-cm, 29 ft. lbs.)





2. INSTALL PRESSURE FEED TUBE
Install the pressure feed tube and a new gasket with the union bolt.

HINT: Make sure the stopper of the pressure feed tube touches the PS vane pump body as shown in the illustration, then torque the union bolt.

Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
3. CONNECT RETURN HOSE
Connect the return hose with the clip.
4. CONNECT 2 VACUUM HOSES
Connect the 2 vacuum hoses with the 2 clips.





5. INSTALL DRIVE BELT
Loosen the drive belt tension by turning the drive belt tensioner counterclockwise, and install the belt.
6. INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
a. Install the air cleaner assembly with air cleaner hose with the 3 bolts.
b. Install the clamp.
c. Connect the MAF meter connector.
7. INSTALL AIR CLEANER INLET
Install the air cleaner inlet with the bolt.
8. INSTALL RH REAR ENGINE UNDER COVER
Install the RH rear engine under cover with the 2 bolts.
9. INSTALL ENGINE UNDER COVER
Install the engine under cover with the 16 bolts.
10. BLEED POWER STEERING SYSTEM