Tire Pressure Antenna Front LH

TIRE PRESSURE ANTENNA FRONT LH
REPLACEMENT

HINT:
^ Replace the RH side by the same procedure as the LH side.

1. REMOVE WHEEL HUB ORNAMENT SUB-ASSEMBLY
a. Remove the 10 bolts and wheel hub ornament sub-assembly.
2. REMOVE FRONT WHEEL
a. Remove the 5 nuts and front wheel.
3. REMOVE TIRE PRESSURE ANTENNA FRONT LH





a. Remove the front fender liner.
b. Disconnect the connector.





c. Remove the 2 bolts and tire pressure antenna.
4. INSTALL TIRE PRESSURE ANTENNA FRONT LH





a. Install the tire pressure antenna with the 2 bolts.
Torque: 7.8 Nm (80 kgf-cm, 69 inch lbs.)





b. Connect the connector.
c. Install the front fender liner.
5. INSTALL FRONT WHEEL
a. Install the front wheel with the 5 nuts.
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
6. INSTALL WHEEL HUB ORNAMENT SUB-ASSEMBLY
a. Install the wheel hub ornament sub-assembly with the 10 bolts.
Torque: 20 Nm (204 kgf-cm, 15 ft. lbs.)
7. REGISTRATION OF TRANSMITTER ID
8. INSPECT TIRE PRESSURE WARNING SYSTEM