Steering Angle Sensor: Service and Repair

STEERING SENSOR
REPLACEMENT
1. PRECAUTION
2. SHIP MODE SETTING (W/CD CHANGER)
3. SEPARATE BATTERY NEGATIVE TERMINAL
4. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
5. REMOVE SWITCH & VOLUME CASE
6. REMOVE STEERING PAD SWITCH MODULATOR
7. REMOVE HORN BUTTON ASSEMBLY
8. REMOVE STEERING WHEEL ASSEMBLY
SST 09950-50013 (09951-05010, 09952-05010, 09953-05020, 09954-05021)
9. REMOVE TURN SIGNAL SWITCH ASSEMBLY
10. REMOVE SPIRAL CABLE SUB-ASSEMBLY
11. REMOVE STEERING SENSOR
12. INSTALL STEERING SENSOR
13. ADJUST CENTER FRONT WHEEL
14. INSTALL SPIRAL CABLE SUB-ASSEMBLY
15. CENTER SPIRAL CABLE
16. INSTALL TURN SIGNAL SWITCH ASSEMBLY
17. INSTALL STEERING WHEEL ASSEMBLY
Torque: 50 Nm (510 kgf-cm, 37 ft. lbs.)
18. INSPECT STEERING WHEEL CENTER POINT
19. INSTALL HORN BUTTON ASSEMBLY
Torque: 8.8 Nm (90 kgf-cm, 78 inch lbs.)
20. INSTALL STEERING PAD SWITCH MODULATOR
21. INSTALL SWITCH & VOLUME CASE
22. INSPECT SRS WARNING LIGHT
23. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
24. PERFORM STEERING ANGLE SENSOR ZERO POINT CALIBRATION