Tire Pressure Module: Service and Repair

TIRE PRESSURE MONITOR RECEIVER ASSEMBLY
REPLACEMENT
1. SHIP MODE SETTING
2. SEPARATE BATTERY NEGATIVE TERMINAL
a. Disconnect the negative terminal.
3. REMOVE CONSOLE UPPER PANEL GARNISH REAR
4. REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER
5. REMOVE AIR CONDITIONER CONTROL ASSEMBLY
6. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY LOWER CENTER
7. SHIP MODE CONFIRMATION





8. REMOVE TIRE PRESSURE MONITOR RECEIVER ASSEMBLY
a. Disconnect the 2 connectors.
b. Remove the 2 bolts and receiver assembly.





9. INSTALL TIRE PRESSURE MONITOR RECEIVER ASSEMBLY
a. Install the receiver assembly with the 2 bolts.
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
b. Connect the 2 connectors.
10. INSPECT TIRE PRESSURE WARNING SYSTEM