Lighting and Horns: Service Precautions

LIGHTING SYSTEM

PRECAUTION

PRECAUTION OF HEADLIGHT BULB REPLACEMENT
a. When any defect such as deformation, crack, dent, chipping, etc. is identified on the discharge headlight (especially, on the light control ECU), replace it with a new one.
b. Even if the operation seems to be normal, the fail-safe function may be defective.
c. Since bulbs of the discharge headlight and halogen bulbs (for headlights and fog lights) have pressurized gas inside and can easily be broken if scratched or dropped, special care should be taken. When handling, hold the plastic or metal part and do not touch the glass part with bare hands.
d. Touching the HV socket of the discharge headlight with the headlight dimmer switch ON could generate momentary high voltage of 20,000 V and lead to a serious accident.
e. Never connect a tester to the high voltage socket of the discharge headlight for measurement, as this leads to a serious accident because of high voltage.
f. When performing operation related to the discharge headlight, keep it away from water such as rain, turn off the light control switch, and disconnect the battery terminal and the connector of the light control ECU in advance to avoid electric shock.
g. When performing operation related to the discharge headlight, start it after assembling has been completely over and never light up without a bulb installed.
h. Do not light up the discharge headlight using another power source except vehicle's.