Service Specifications

Crankshaft
Thrust clearance
STD 0.020 - 0.220 mm (0.0008 - 0.0087 inch)
Maximum 0.30 mm (0.0118 inch)
Thrust washer thickness
STD 1.940 - 1.990 mm (0.0764 - 0.0783 inch)
Main journal oil clearance
STD STD 0.026 - 0.040 mm (0.0010 - 0.0016 inch)
U/S 0.25 0.025 - 0.061 mm (0.0010 - 0.0024 inch)
Maximum STD 0.06 mm (0.0024 inch)
U/S 0.25 0.08 mm (0.0031 inch)
Main journal diameter
STD 61.984 - 62.000 mm (2.4403 - 2.4409 inch)
US 0.25 61.745 - 61.755 mm (2.4309 - 2.4313 inch)
Main bearing center wall thickness (Reference)
Mark 1 1.994 - 1.997 mm (0.0785 - 0.0786 inch)
Mark 2 1.997 - 2.000 mm (0.0786 - 0.0787 inch)
Mark 3 2.000 - 2.003 mm (0.0787 - 0.0789 inch)
Mark 4 2.003 - 2.006 mm (0.0789 - 0.0790 inch)
Mark 5 2.006 - 2.009 mm (0.0790 - 0.0791 inch)
Crank pin diameter
STD 51.982 - 52.000 mm (2.0465 - 2.0472 inch)
U/S 0.25 51.745 - 51.755 mm (2.0372 - 2.0376 inch)
Circle runout
Maximum 0.06 mm (0.0024 inch)
Main journal taper and out-of-round
Maximum 0.02 mm (0.0008 inch)
Crank pin taper and out-of-round
Maximum 0.02 mm (0.0008 inch)
Crankshaft pulley x Crankshaft 330 Nm (3,300 kgf-cm, 243 ft. lbs.)
Drive plate x Crankshaft 83 Nm 9850 kgf-cm, 61 ft. lbs.)